Free Unit Converter Widget!
Free Unit Converter Widget!
Free Unit Converter Widget!
|
Free Unit Converter Widget!
- How can I improve the feedback portion of my boost converter circuit . . .
An optimal converter might fit into the same volume as the inductor or capacitor alone, here! For such ratios, it's better to use a tapped or isolated flyback topology The PWM can be closer to 50%, peak currents and voltages are very modest (2-4x the DC value say), device ratings are mild, efficiency can be high, size can be small
- buck converter - POE circuit with small transformer and small volume . . .
POE circuit with small transformer and small volume footprint Ask Question Asked 1 year, 10 months ago Modified 1 year, 10 months ago
- Audio: what do I need to do to get SPDIF data to a speaker?
An SPDIF to PCM (e g I2S) converter is still required, but they avoid the intermediate analog-to-digital conversion stage, keeping the signal entirely in the digital domain until the Class-D output stage filter This is in theory easier to implement and has a lower parts count, but with the caveat that the available options are fairly limited
- Stereo speaker level input to line level mono output converter
I am trying to connect an amplifier with 100W RMS per channel output to a subwoofer that only has a single channel line level input The amplifier does not have a volume controlled line preamp outp
- 230V AC to 5V DC converter, lossless - Electrical Engineering Stack . . .
Is there any IC which converts 230V AC to 5V DC? As lossless as possible I want to connect my microcontroller to an ordinary electrical socket and I don't have enough space available Thanks
- Why are two 1 kΩ resistors used for this additive stereo to mono . . .
The resistors also reduce the mutual bleed-through from RIGHT to LEFT (and v v ) if either of the sources is also connected to a different output, e g L R converted to mono and applied to a pre-amp, but L R individually also applied to a different pre-amp The resistors keep the L R somewhat isolated despite the converter
- 110 V AC to 5 V DC converter circuit and Eagle schematics
I have a circuit and a microcontroller The circuit take 110 V AC, and I need 5 V DC to power the board The circuit is plugged to a power outlet where it takes its power What I need to do is to p
- connector - How to properly convert a balanced (line level) audio . . .
If I connect a mono unbalanced TS (tip-sleeve) 1 4 inch to RCA jack converter to the balanced mixer output, the negative cold signal will be shorted to the sleeve (ground) I know that the simplest way to convert balanced to unbalanced is to short the negative cold signal of a balanced to ground, BUT
|
|
|